Holder Installation Kit
21,00 €
Available when reordered
t-blade Holder Installation Kit
This kit contains everything you need to properly install a t-blade holder to virtually any skate sole.
Using the RMS nut system for installing your t-blade system has the advantage of easy exchange of holder as opposed to rivets,
which need to be cut-off and redone using special equipment.
With the RMS nut system, a turn of a screwdriver is all that is needed to replace your holders with a new one.
Kit includes:
- Universal wrench with storage compartment in handle
- RMS nut puller for setting the nuts into the skate sole
- Long and short T20 bit inserts for installation
- 14 x (M4 x 8 mm) short T20 screws for the front area
- 12 x (M4 x 12mm) long T20 screws for the back area
- 26 RMS Nuts
- Storage Pouch
Lindauer Str. 1a
86842 TürkheimResponsible person: support@t-blade.shopWarnings and safety information:
Warnings & Safety Information
T-Blade The products are sporting goods for use in ice hockey, figure skating and similar sports.
Ice sports. Use is entirely at your own risk.
-
Risk of injury: runners, Runner And interchangeable blades are sharp. In case of improper use
Handling poses a risk of cuts and injuries. -
Assembly & Replacement: The exchange of Runnern, stubbies or other system components
Installation must be carried out only according to the manufacturer's instructions. Improper installation can lead to material failure and loss of control.
or lead to injuries. -
Regular controll: Before each use, all fasteners, screws and system parts must be checked.
to check for secure fit, wear and damage. -
Wear parts: Runner and replaceable blades are subject to natural wear and tear and must be replaced when necessary.
Wear and tear should be replaced in a timely manner. -
Protective gear: Wearing appropriate protective equipment (e.g. helmet, pads) is strongly recommended.
empfohlen. -
Not for children without supervision: Use by children should only be under supervision and
Instructions will follow. -
Not a toy: T-Blade These products are not toys and are not intended for improper use.
Intended use.
The manufacturer and distributor accept no liability for damages or injuries caused by improper use.
These problems can arise from improper use, incorrect assembly, or lack of maintenance.
Discover More
Battery bit insert
9,99 €
Replacement screw made of plastic for Stabilisatoren + Torx key
12,99 €
Metal replacement screw for Stabilisatoren
19,99 €
Plastic nut for Stabilisator
0,04 €
Metal nut for Stabilisator
0,29 €
System key – black plastic
5,99 €
System key – metal
9,99 €


Reviews
Clear FiltersThere are no reviews yet.